FAQs
- What OFFBOARD® Shields fit on my boat?
- What do you mean “Insert”?
- I have a motor yacht that uses a mooring line greater
than one inch diameter, can I use the OFFBOARD® Shields?
- How many do I need?
- How do I attach them to the mooring line?
- How do I detach the Shield from the line?
- What’s the best way to store the shields when
not in use?
- How do I change the size of the mooring line hole on
the 15 inch Shield?
- What if the insert I selected is too loose?
- What if the insert I selected is too tight?
- I lost the insert package. Where can I get a replacement?
- I lost one insert out of the package. Where can I
get a replacement?
- My mooring line is 7/16 diameter, will it work with
the 10 inch shield?
- What are the reasons why I should use these products?
- What happens if I loose my keys to the lock?
- How do I clean the OFFBOARD Shields?
- Can I resell the Shields to others?
What OFFBOARD® Shields fit on my boat?
This depends not on the size of your boat but on what size line
you use for mooring. The larger the mooring line, the larger potential
pest can gain access to your boat. OFFBOARD® Shields now come
in three sizes. For mooring lines less than a 1/2 inch, use the 10
inch shields. For larger sizes, use the 15 or 17 inch shields with the
appropriate inserts.
What do you mean “Insert”?
The 15 Inch Shield is built so that it can be used on a one inch
diameter mooring line. For lines less than one inch in diameter,
an insert is used to reduce the center hole so that smaller mooring
lines can be used. Four inserts (1/2, 5/8, 3/4, or 7/8 inch) are
provided free when the 15 Inch shield is purchased. You select the
one that fits your mooring line.
I have a motor yacht that uses a mooring line
greater than one inch diameter, can I use the OFFBOARD™ Shields?
Yes, our
17 Inch Shield will support mooring lines up to 2 ½
inches in diameter. Inserts will allow mooring lines of 1½
through 2 inches in diameter to be used.
How many do I need?
Good question. It depends on your mooring requirements and the type
or size of your boat. For houseboats, it depends on the size of
the houseboat, but typically four mooring lines are needed for security.
For cruisers, two mooring lines could secure the boat when beaching
the boat. When in a slip two pair may be needed depending on the
configuration of the slip and number of mooring lines used.
How do I attach the Shield to the mooring line?
Each OFFBOARD® Shield has a patented door that opens so that
it can be attached to the mooring line. Once the line is inserted,
the spring hinge door is closed and the shield is secured to the
line. The patented spring hinge holds the door closed and clamps
the shield on the line. Review the instruction videos for additional information.
How do I detach the Shield from the line?
Simply open the spring hinge door and remove the mooring line. Of
course, if the optional lock is installed, you have to unlock the
lock before the Shield can be removed. Review the instruction videos for additional information.
Return to top
What’s the best way to store the
Shields when not in use?
The Shields can be stored in the anchor locker with the mooring
lines. We recommend using the custom designed small or large tote bag with its
divided center for neat and tidy storage on your vessel. The tote
bags are available for the 10 inch Shield and 15/17 inch Shield sets and have a mesh
bottom which allows for drainage when the shields are stored while
still wet. They are available in three marine colors.
How do I change the size of the mooring
line hole on the 15 inch Shield?
First select the insert desired. Make sure the door and the insert
is clean and free from dirt or the insert won’t properly fit
into the door. Assuming that the door does not have an insert already
installed, simply hold the door open and place the insert into the
two dove tails at the bottom of the door and press into place. The
insert has to go all the way in or the door will not close. Some
pressure is expected. Review the instruction video for additional information.
What if the insert I selected is too loose?
Mooring lines vary in size as they age. If you have selected an
insert (for example a 3/4 inch insert) and it is too loose, replace
it with a 5/8 insert. The door with the new insert will be a tight
fit and you may find that you might have to gently assist the door
in completely closing.
What if the insert I selected is too tight?
Mooring lines vary in size even if they are new. If you have selected
an insert (for example a 3/4 inch insert) and it is too tight, replace
it with a 7/8 insert. The door with the new insert will be a looser
fit. Whatever size you choose, you should allow the door to completely
close and have afit snug on the line. The shield should not be able to
spin or slide along the line.
I lost the insert package. Where can I
get a replacement?
Email us for a replacement
kit.
I lost one insert out of the package.
Where can I get a replacement?
Email us for a replacement
kit. We do not keep individual sizes.
Return to top
My mooring line is 7/16 diameter, will
it work with the 10 inch shield?
If the line is braided it will fit.
What are the reasons why I should use
these products?
The shields are another means of protection against vermin gaining
access to your boat. See our White Paper – “Are you
being Watched”. Vermin residing around water are very aware
of the smells of food that a moored boat brings into their environment.
Your extended mooring line looks like a gang plank to your boat.
The OFFBOARD™ shield is an obstacle to their access success.
The shield is made of long lasting plastic with stainless steel
components and will probably outlast the life of your boat. Therefore,
the purchase is a wise investment.
What happens if I loose my keys to the
lock?
We do not keep any master keys. So if you have lost all of them,
you should contact a lock smith. Each lock comes with two keys.
Each pair of locks sold by us is matched with two pair of keys.
So that’s a total of four identical keys. That is, the locks/keys
we sent you are interchangeable. If you have lost one pair, you
can use the other while you get duplicates. It is strongly suggested
that one key be attached to the ignition key chain.
How do I clean the OFFBOARD™ Shields?
Use warm water and a mild soap solution.
Can I resell the Shields to others?
The warranty is extended only to the original owners who purchase
the product
through Foothills Products or their authorized dealers. Contact us if you want to become a dealer.
Return to top
|
